Whites PRIZM IV Manual do Utilizador descarregar pdf (Página 8)

⇠

Prizm™

II • III • IV • V

Getting Started (Prizm™ II, III, IV, V)

1. Once assembled with good batteries installed, press ON/

OFF.

2. Due to the many metals used in modern construction it is

best to use and practice outdoors.

3. Sweep the round search coil from side to side over ground

evenly (near to or touching ground surface) keeping it very

close to the ground throughout each pass and overlapping

each pass as if mopping a oor. About two seconds per pass

from left to right, and two seconds returning from right to left

is necessary for the Prizm to perform as designed. Sweeping

too slowly (signicantly less

than two seconds per pass)

will deter good performance.

It is also necessary for the

round search coil to be mov

ing (sweeping) for the Prizm

to detect and identify metals.

Once an interesting signal has

been located, (Step #6) the P/P

(pinpoint) button can be used

to allow much slower search

coil movement isolating exactly

where to dig.

4. Solid repeatable beeps and

repeatable display after several

passes indicates an interesting

metal target.

5. Broken, sputter, or inconsistent beeps and display, indicates

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Sem comentários

Whites PRIZM IV Manual do Utilizador Página 8